Download MLE 1236.4.0.21 and The Tutorial

MLE 1236.4.0.21 is a new engine (April 2009) for SEAL Online cheat. By using MLE 1236.4.0.21, you can use Cegel cheat for SEAL Online. And you're also can I download MLE 1236.4.0.21 for FREE! After you download, I will give you the tutorial for the General Settings  for it below. But, before you read the tutorial you must download MLE 1236.4.0.21 first by click the link below :

MLE 1236.4.0.21

For the tutorial, you can read it below (the tutorial is taken from Game Cheetah)  :

[x] Show undo button
[x] Show advance options
[x] Update the list of found addresses and after scanning
[x] Center MoonLight Engine when bringing to front
[x] Hide some/all windows instead oftrying to bring MoonLight Engine to 1

[x] Show values as if they are signed
[ ] Show and work with biniaries as if they are decimals
[ ] Simple paste

[ ] Even autoattach when another process has already been selected

Update interval [500]ms Found address list update interval [1000]ms
Freeze interval [250]ms



Scan Settings:

[ ] Fast scan on by default
[ ] Enable Hyperscan when possible
[ ] Don't scan memory that is protected with the No Cache option
[ ] Keep low memory usage when doing an "Unknown Initial Value Scan" with Hyper Scan

Scan with the following memory types:

[x] MEM_PRIVATE:Memory that is private
[x] MEM_IMAGE:Memory that is mapped into the view of an image section
[ ] MEM_MAPPED: Memory that is mapped into the view of a section (Eg. File mapping, slow)

[x] Run scan in seperate thread
Thread priority [Higher]


File Associations:

[x].CT (Standard Cheat Table)



Code Finder:

[x] Use Debug Registers (aka Hardware Breakpoints)
[ ] Memory Access Exceptions

[x] Try to prevent detection of the debugger
[ ] Handle beakpoints not caused by MLE



Assembler:
[x] Show disassembler
[x] Show debugger options
[x] Use hardware breakpoints (Max3)
[ ] Use int3 instructions for breakpoints (Unlimited)

[x] Replace incomplete opcodes with nops
[x] Ask for replce with nop

[x] Try to prevent detection of the debugger



Extra:

[x] Query memory region routines
[x] Read/Write Process Memory (Will cause slower scans)
[x] Open Process

[ ] Undo changes to MLE
[ ] Force memory to be writable in case the standard method is blocked

[x] Enable use of the Process Watcher
[x] Use kernalmode debugger options when possible
[ ] Use Global Debug routines

[ ] Stealth mode (Usermode)
[ ] Stealth Mode (Kernelmode)

Oh and, the value is not changed for 1hitkill and stuff, just apply those settings, and you're set.

Good luck! ^.^